Skip to main content

Our

POWDER COATING

Difference

Environmentally Friendly Powder Coating

Wishbone Site Furnishings supports earth-friendly "green" building practices. Our powder coating is environmentally friendly and contains no VOCs. Chemicals used in our processes can be neutralized and desposed of safely, and powder coating reduces the impact on human health compared to other coatings.
Technical Data Sheet

Super Durable TGIC Powders Meet or Exceed AAMA Specifications

Super Durable polyester powders have become the mainstay in the architectural / railing industry. Where standard polyester powders will provide only 2 years of gloss retention, Super Durable TGIC powder will retain greater than 50% of its original gloss for a minimum of 5 years in exposures comparable to South Florida. Our Super Durable Powders meet or exceed the 7.9 weathering parameters of the American Architectural Manufacturing Association (AAMA) 2604-2605 specifications, and Wishbone meets AAMA 2605 commercial specifications using Spraylat "Newlar"' powders.

  • 32 Standard and available custom colour options

  • Super durable polyester resin technology
  • Meets the requirements of Qualicoat Class II, GSB Master and BS EN 1206
  • Meets AAMA 2604 specification

Cleaning Prior To Applying Powder

Curing Prior To Applying Powder

Staging Prior To Applying The Powder

Applying The Powder

Applying The Powder

Ensuring The Oven Is At The Correct Temperature

Baking The Powder

Checking The Thickness Of The Finished Coat

Super Durable Standard Powder Colours

Textured Powders

These powders have a fine or coarse furface texture that helps to minimize blemishes and minor scratches.

Low Lustre Powders

These powders resist fingerprints on a surface that is smooth and easy to clean.

Gloss Powders

These powders are bold, bright and shiny.


Our Process Starts Where Others Finish

Stage One

Consists of a heated alkaline based degreaser / cleaner to remove mixed metals, oils and contaminates prior to powder coating.

Stage Two

An aerated cold water raise to remove the degreaser / cleaner solution.

Stage Three

An aerated acid based solution to etch and further clean the substrate of any contaminates and welding smoke.

Stage Four

An aerated fresh water rinse to remove the degreaser and cleaning solution.

Stage Five

A seal coat that has been added to our process, E-CLPS. E-CLPS is a chrome-free, non-phosphate liquid coating used to protect aluminum and zinc alloys with a clear, nearly colorless chemical Dried In Place (DIP) coating. When applied the coating has excellent paint bonding properties and affords under-film protection.

Add some

VIBRANCE

to your next project